How to transfer my entire MetaMask wallet to a Trezor?

Preparation Requirements

1. A functional Trezor hardware wallet with firmware updated to the latest stable version.

2. A computer running a supported operating system with USB port access and administrative privileges.

3. The official Trezor Suite application installed and verified as authentic via checksum or signature.

4. MetaMask browser extension installed and logged into the target wallet containing the assets to migrate.

5. Physical access to both devices simultaneously, with no network interference or background crypto applications running.

Seed Phrase Compatibility Check

1. Confirm that the MetaMask wallet was created using the BIP-39 standard seed phrase—this is mandatory for direct restoration on Trezor.

2. Locate the 12-word recovery phrase used during MetaMask setup; it must be written down and stored offline.

3. Verify that no custom derivation paths were manually configured in MetaMask beyond the default m/44'/60'/0'/0 for Ethereum.

4. Ensure no third-party token contracts or non-standard ERC-20 implementations rely on unique signing logic incompatible with Trezor’s deterministic signing engine.

5. Cross-check the first three words of the seed against Trezor Suite’s import interface to confirm recognition before proceeding.

Trezor Wallet Initialization

1. Launch Trezor Suite and select “Set up new device” followed by choosing the correct model variant.

2. Connect the Trezor via USB and follow on-device prompts to set a PIN code—record it separately from the seed.

3. Choose “Restore wallet from seed” instead of generating a new one; enter each word precisely in order using the device’s screen.

4. Confirm the displayed address matches the first Ethereum address derived in MetaMask under the same derivation path.

5. Wait for full blockchain synchronization to complete before initiating any transfers; this may take several minutes depending on network load.

Asset Migration Execution

1. In MetaMask, switch to the Ethereum mainnet and open the account view showing all tokens and balances.

2. Initiate a native ETH transfer to the primary Ethereum address shown in Trezor Suite under the restored wallet.

3. For each ERC-20 token, use the “Send” function and paste the exact Trezor-derived address—not the MetaMask address.

4. Set gas fees manually to avoid stuck transactions; consult Etherscan’s real-time gas tracker before submission.

5. Monitor transaction hashes on Etherscan until final confirmation count reaches twelve for full settlement assurance.

Frequently Asked Questions

Q: Can I import my MetaMask seed directly into Trezor without resetting the device?Yes. Trezor Suite supports seed restoration at any time—even on a device previously used for other wallets—as long as the firmware permits BIP-39 import.

Q: What happens if I mistype one word during seed entry on Trezor?The device will reject the entire phrase and require re-entry from the beginning. No partial validation occurs; accuracy is enforced at the final confirmation step.

Q: Will my NFTs automatically appear in Trezor Suite after restoring the seed?Yes—if they reside on Ethereum mainnet and conform to standard ERC-721 or ERC-1155 specifications, Trezor Suite detects them automatically upon address synchronization.

Q: Is it safe to keep MetaMask installed while using Trezor for signing?No. MetaMask must be disconnected or removed from the browser during active Trezor usage to prevent accidental signing requests routed through the extension instead of the hardware device.