How to configure MetaMask for Xai gaming? (Arbitrum Orbit)

Network Configuration Steps

1. Launch the MetaMask browser extension and click the network selector dropdown located in the top-center of the interface.

2. Select “Add Network” from the bottom of the dropdown menu to initiate manual network configuration.

3. Input the official Xai RPC endpoint: https://xai-chain.net/rpc.

4. Set Chain ID to 662200, which is the canonical identifier for the Xai chain on Arbitrum Orbit.

5. Enter “Xai” as the Network Name and “XAI” as the Symbol for native token display.

6. Paste the block explorer URL: https://explorer.xai-chain.net, ensuring transaction verification remains accessible.

7. Confirm submission; the network will appear as “Xai” in MetaMask’s network list immediately after saving.

Wallet Address Validation

1. After adding the Xai network, verify that your wallet address remains unchanged across networks—MetaMask preserves the same Ethereum-derived address on Xai.

2. Confirm address checksum compliance by checking that uppercase and lowercase letters match EIP-55 formatting standards.

3. Initiate a test transaction using a small amount of XAI or bridged ETH to validate signature compatibility and nonce handling.

4. Monitor the transaction hash on https://explorer.xai-chain.net to confirm inclusion in a block within expected finality windows.

5. Cross-check balance updates in MetaMask’s asset panel against on-chain state using the explorer’s account view.

Token Import Protocol

1. Navigate to the “Assets” tab inside MetaMask while connected to the Xai network.

2. Click “Import Tokens”, then select the “Custom Token” tab.

3. Enter the official XAI token contract address: 0x93a8f44b358ab9e59b7c6e25e243a5b1b145d4e3.

4. Ensure the token symbol auto-fills as “XAI” and decimals are set to 18—no manual override is required if the address is correct.

5. Click “Next”, then “Add Tokens” to finalize import; the XAI balance will populate automatically upon next refresh.

Bridge Integration Setup

1. Visit the official Xai bridge at https://bridge.xai-chain.net using the same browser where MetaMask is installed.

2. Connect MetaMask to the bridge interface and ensure it is set to Ethereum Mainnet or Arbitrum One before initiating transfer.

3. Select “Xai” as the destination chain and confirm gas fee estimates in ETH or ARB depending on source network.

4. Approve the token allowance transaction when prompted, then submit the deposit—this triggers cross-chain message passing via Nitro stack.

5. Wait for the bridge confirmation screen showing “Ready to claim” status, then switch MetaMask to Xai network and complete the claim step.

Frequently Asked Questions

Q: Does MetaMask support Xai natively without manual RPC entry?A: No. As of April 2026, Xai does not appear in MetaMask’s default network list and requires manual RPC configuration using verified parameters.

Q: Can I use the same seed phrase for Xai that I use for Ethereum or Arbitrum One?A: Yes. Xai derives addresses using the same BIP-39 and HD wallet standards, preserving full key compatibility across EVM-compatible chains.

Q: Why does my XAI balance show zero even after successful bridge claim?A: This occurs if the XAI token was not manually imported using its exact contract address. Balance visibility depends on explicit token registration—not automatic detection.

Q: Is gas paid in ETH or XAI on the Xai network?A: Gas fees on Xai are denominated and paid exclusively in XAI; ETH held on Xai has no utility unless converted via designated pools.