Scan code transfer tutorial

Preparations before scanning the QR code to transfer: KeyPal 2 has completed initialization KeyPal 2 has been successfully associated with TokenPocket App The corresponding KeyPal 2 wallet address has been added to TokenPocket App The KeyPal2 device has been turned on and the PIN code can be entered normally The current wallet has sufficient balance (including the main currency handling fee, such as BNB/ETH/TRX/SOL, etc.) Note: The connection method between KeyPal 2 and TokenPocket is "scan code connection". (If the current connection is Bluetooth, you can also switch to scan code connection in TokenPocket App before transferring money.) Tip: During the scan code transfer process, please ensure that the brightness of the mobile phone screen is moderate and the QR code is complete and clear to improve the success rate of device recognition. Step 1: Confirm that the connection method is scan code connection (if it is currently a Bluetooth connection, you can switch it by following the steps below) Select the corresponding KeyPal 2 hardware wallet address in TokenPocket - after entering the wallet main interface, click "..." in the upper right corner - enter the wallet details - click the "hardware device icon" in the upper right corner - select "Connection method" - switch to "scan code connection". After completion, return to the wallet page and initiate a transfer by scanning the QR code. Step 2: Initiate a transfer in TokenPocket App (take BNB as an example) Step 1: Click "Transfer" In TokenPocket App, enter the corresponding KeyPal2 wallet and click "Transfer". Step 2: Select the transfer currency. Select the currency to be transferred, for example: BNB. Step 3: Fill in the receiving address. The receiving address can be obtained in the following ways: a. Paste the address; b. Scan the QR code to obtain the address. Step 4: Enter the transfer amount. Enter the amount to be transferred this time. Step 5: Confirm and call the hardware wallet Click "OK" and then select "Confirm via Hardware Wallet". At this time, the App will display the QR code to be signed and wait for KeyPal 2 to scan the code. Step 3: Use KeyPal 2 to scan and sign. Step 1: Scan the device to identify the transaction QR code. On the main interface of the KeyPal2 hardware wallet, click the device button "[-]" to identify the QR code displayed on the App. Step 2: Enter the device PIN code. Enter the device PIN code according to the prompts. Step 3: Confirm the transaction details. Check the transaction information on the device, including but not limited to: currency, amount, receiving address, network handling fee (if displayed). After confirming that it is correct, sign on the device. Step 4: The signature is successful and the device displays the signature QR code. After the signature is completed, the KeyPal2 device will display the signature result QR code. Step 4: Scan the signature result in the TokenPocket App and send it Step 1: Use the App to scan the device QR code In the TokenPocket App, click "[-] Scan Signature Result" and scan the QR code displayed on the KeyPal2 device. Step 2: After confirming that the sending scan is completed, click "Confirm to Send". At this point the transaction has been signed and successfully issued (broadcast to the chain). Complete the transfer After the transfer is completed, just click Return on the KeyPal2 device. At this point, the scan code transfer process has been completed. Warm reminder: Before scanning the QR code to transfer money, please confirm that the current connection method is the scan QR code connection. Before each signature, please be sure to check the transaction details on the KeyPal2 device, and the content displayed on the device shall prevail. Please confirm that the transfer network is consistent with the network to which the receiving address belongs (such as BNB/BSC, ETH, TRON, SOL, etc.). When transferring, please reserve enough main currency to pay the on-chain handling fees. Do not disclose your mnemonic phrase, private key or PIN to anyone.