How to Enable Withdrawal Whitelist on Binance? Security Tutorial

Accessing the Security Center

1. Log in to your Binance account via the official website www.binance.com or the verified mobile application.

2. Navigate to the top-right corner of the interface and click on your profile icon to open the dropdown menu.

3. Select Security Center from the list—this section houses all critical account protection features.

4. Ensure your session is active and authenticated with two-factor verification before proceeding further.

5. Confirm that your device’s time and network settings are synchronized to prevent token mismatch errors during verification steps.

Locating Whitelist Activation Option

1. Within the Security Center, scroll down to the Asset Security subsection.

2. Identify the entry labeled Withdrawal Address Management and click on it to expand its configuration panel.

3. Locate the toggle switch labeled Enable Withdrawal Address Whitelist—it appears as an inactive gray slider by default.

4. Click the toggle to activate it; a system prompt will immediately appear requesting secondary identity confirmation.

5. The interface will not proceed unless both Google Authenticator and email verification are successfully completed in sequence.

Adding Your First Verified Address

1. After whitelist activation, the page automatically redirects to the address management list view.

2. Click the Add Address button located at the top-right of the address table.

3. Choose the correct blockchain network corresponding to your target wallet—for example, ETH (Ethereum) or TRX (TRON).

4. Paste the full destination wallet address into the input field; the system performs real-time syntax validation and displays a green checkmark upon format compliance.

5. Enter the six-digit code sent to your registered email—this step enforces ownership proof and triggers a mandatory 24-hour cooling period before the address becomes operational.

Verifying Inclusion in Merkle Reserve Audit

1. Return to the main dashboard and locate the Merkle Validator tool under the Funds tab.

2. Input the exact wallet address you added to the whitelist into the validator field.

3. Click Verify to initiate on-chain hash lookup against the latest published Proof of Reserves report dated 2026-04-30.

4. A successful match returns a green status badge showing “Confirmed in PoR Snapshot” alongside the Merkle root hash and block height.

5. If no match appears, double-check capitalization, checksum validity, and whether the address was included in the most recent audit cycle.

Managing Whitelist Entries Post-Activation

1. Each whitelisted address displays a truncated format: 0x7a8b…c3f9|Cold Wallet, where the suffix reflects your custom label.

2. To edit a label, click the Edit icon next to the address and submit a new 2–20 character descriptor—no server transmission occurs.

3. Deleting an address requires checking the irreversible action box and re-entering your current Google Authenticator code.

4. All modification timestamps and associated blockchain heights are permanently recorded and accessible via Export Full Log in CSV format.

5. Any withdrawal attempt targeting a non-whitelisted address fails instantly with error code WAL-403 and zero gas consumption on-chain.

Frequently Asked Questions

Q: Can I enable the withdrawal whitelist without completing KYC? No. Binance mandates Level 2 KYC verification—including passport upload and live facial recognition—before granting access to whitelisting controls.

Q: Does the 24-hour cooling period apply to edits or only new additions? It applies exclusively to newly added addresses. Modifications to labels or deletion actions take effect immediately after secondary verification.

Q: What happens if I lose access to my Google Authenticator during whitelist setup? You must use your pre-configured recovery codes or contact Binance Support through the verified backup email channel to reset authentication—no bypass is permitted.

Q: Are hardware wallet addresses supported in the whitelist system? Yes. Ledger and Trezor-generated addresses are fully compatible provided they conform to the selected network’s address standard and pass syntax validation.